Windshield Adjustment - Victory Motorcycles Vision Tour Rider's Manual

Pedal Adjustment
The brake pedal and gear shift pedal controls can be adjusted
to a front, rear or center position. The center position is the
factory setting.
Tip: An accessory linkage rod is needed to fully adjust the gear shift
pedal control.
1. Remove the screw from the footwell support.
Tool: 6 mm Allen wrench
2. Slide the control forward or rearward in its track until
the threaded hole of the control aligns with the desired
hole in the footrest support.
3. Reinstall the screw.
Torque: 96 in-lbs (11 Nm)
4. After adjusting the shift pedal, always readjust the shift
linkage rod. Loosen both jam nuts on the linkage and
turn the shaft until the footpeg is about 90 mm from the
floorboard (or to desired height). Tighten both jam nuts.
Torque: 96 in-lbs (11 Nm).

Windshield Adjustment

Use the motorized windshield adjustment switch (if
equipped) to adjust the windshield. See page 31. If the
motorcycle is not equipped with this feature, you can
manually adjust the windshield.
1. Park the motorcycle on a firm, level surface. Turn the key
to the OFF position.
2. Remove the windshield trim panel. See page 85.
3. Remove the retaining clip.
4. Hold slight downward pressure on the bottom of the
windshield (it is under slight upward spring pressure).
Remove the clevis pin.
5. Slide the windshield inner bracket to align with one of the
optional holes in the outer bracket. Reinstall the clevis
pin. Reinstall the retaining clip in the clevis pin.
6. Reinstall the windshield trim panel.
Instruments, Features and Controls
Center Adjustment
Position
Retaining Clip
Clevis Pin
37