Steering System - Can-Am DS 90 Operator's Manual

MAINTENANCE PROCEDURES
Wheel Removal and Installation
Loosen bolts then lift vehicle. Place a
support under vehicle. Remove bolts
then remove wheel.
At installation, it is recommended
to apply anti-seize lubricant on bolts
threads. Gently tighten bolts in a
criss-cross sequence then apply a fi-
nal torque.
WHEEL NUTS TORQUE
Front and rear
Wheel Bearing Condition
Push and pull the wheels from the up-
per edge to feel the play. See an autho-
rized Can-Am dealer if there is any play.
TYPICAL
______________
94
40 N•m ± 4 N•m
(30 lbf•ft ± 3 lbf•ft)

Steering System

Front Knuckle Lubrication
DS 70 and DS 90
Lubricate front knuckles. Use SUS-
PENSION GREASE (P/N 293 550 033)
or an equivalent. There is a grease fit-
ting on each knuckle.
vmo2008-008-037_a
TYPICAL
1. Grease fitting