Can-Am DS 90 Operator's Manual page 68

OPERATING INSTRUCTIONS
vmo2009-004-006_a
FULL CHOKE POSITION
Press and hold LH brake lever.
Press the engine start button and hold
until engine starts.
vmo2009-004-005_c
1. Engine start button
NOTICE
Do not hold start button
more than 10 seconds. A rest pe-
riod should be observed between
the cranking cycles to let starter cool
down. Pay attention to battery; do
not discharge it.
NOTE: Throttle assist may be used to
help starting the engine faster. Press
the throttle lever slightly; if it is pressed
too much, the choke system will not be
activated.
______________
66
vmo2008-020-003_a
TYPICAL
1. Throttle lever
2. To accelerate
3. To decelerate
Release the engine start button imme-
diately when engine has started.
After a few seconds, adjust choke
lever until the best engine RPM is
achieved.
NOTE: Overusing choke may flood en-
gine and make it hard to start. Refer to
TROUBLESHOOTING
When the engine is warm, place choke
lever to OFF position and release
brakes.
vmo2009-004-005_d
OFF POSITION
if it occurs.