Table of Contents
Advertisement
NOTE: Your computer's Service Tag is stored in the system board. You must enter the Service Tag in
the BIOS setup program after you replace the system board.
Procedure
1.
Replace the side I/O bracket on the system board.
2.
Align the screw holes on the system board with the screw holes on the display-panel base.
3.
Replace the screws that secure the system board to the chassis.
4.
Route and connect all the cables to the connectors on the system board.
Post-requisites
1.
Replace the
coin-cell
2.
Replace the
wireless
3.
Replace the
hard
drive.
4.
Replace the processor.
5.
Replace the
processor
6.
Replace the
processor
7.
Replace the
I/O
bracket.
8.
Replace the
power-supply diagnostic
9.
Replace the
VESA-mount
10. Replace the
system-board
11. Replace the
memory
12. Replace the
back
cover.
13. Replace the
stand
assembly.
Entering the Service Tag in the BIOS
1.
Turn on the computer.
2.
Press <F2> when the DELL logo is displayed to enter the system setup program.
3.
Navigate to the main tab and enter the Service Tag in the Service Tag Input field.
Removing the Camera
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in
inside your computer, follow the instructions in
safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Prerequisites
1.
Remove the
stand
2.
Remove the
back
cover.
3.
Remove the
memory
4.
Remove the
system-board
5.
Remove the
hard
drive.
6.
Remove the
VESA-mount
52
battery.
card.
fan.
heat-sink.
board.
bracket.
shield.
module(s).
Before Working Inside Your
assembly.
module(s).
shield.
bracket.
Computer. After working
After Working Inside Your
Computer. For more
Advertisement
Table of Contents
