Table of Contents
Advertisement
1.
screws (2)
3.
power cable
Replacing the Optical Drive
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in
inside your computer, follow the instructions in
safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
1.
Route the power cable and data cable through the routing guides on the display-panel base.
2.
Align the screw holes on the interposer with the screw holes on the display-panel base.
3.
Replace the screws that secure the interposer to the display-panel base.
4.
Connect the power and data cables to the system board.
5.
Align the screw holes on the optical-drive bracket with the screw holes on the optical drive.
6.
Replace the screws that secure the optical-drive bracket to the optical drive.
7.
Align the tabs on the optical-drive bezel with the slots on the optical-drive assembly and snap it into
place.
8.
Slide the optical-drive assembly into the optical-drive bay until it snaps into position.
Post-requisites
1.
Replace the
I/O
bracket.
2.
Replace the
power-supply diagnostic
3.
Replace the
VESA-mount
4.
Replace the
system-board
5.
Replace the
back
cover.
6.
Replace the
stand
assembly.
Before Working Inside Your
board.
bracket.
shield.
2.
data cable
Computer. After working
After Working Inside Your
Computer. For more
39
Advertisement
Table of Contents
