Table of Contents
Advertisement
1.
screws (2)
3.
left antenna module
Replacing the Antenna
WARNING: Before working inside your computer, read the safety information that shipped with
your computer and follow the steps in
inside your computer, follow the instructions in
safety best practices, see the Regulatory Compliance home page at dell.com/
regulatory_compliance.
Procedure
1.
Align the screw holes on the antenna modules with the screw holes on the display bezel.
2.
Replace the screws that secure the antenna modules to the display bezel.
3.
Route the antenna cables through the routing guides on the display-panel base.
4.
Adhere the tape to secure the antenna modules to the display bezel.
Post-requisites
1.
Replace the
system
2.
Replace the
coin-cell
3.
Replace the
wireless
4.
Replace the processor.
5.
Replace the
processor
6.
Replace the
processor
7.
Replace the
power-supply
8.
Replace the
power-supply
9.
Replace the
optical
10. Replace the
I/O
bracket.
11. Replace the
power-supply diagnostic
12. Replace the
converter
13. Replace the
control buttons
14. Replace the
VESA-mount
15. Replace the
hard
drive.
16. Replace the
system-board
17. Replace the
memory
18. Replace the
back
cover.
19. Replace the
stand
assembly.
56
Before Working Inside Your
board.
battery.
card.
fan.
heat-sink.
unit.
fan.
drive.
board.
board.
board.
bracket.
shield.
module(s).
2.
right antenna module
4.
securing tape
Computer. After working
After Working Inside Your
Computer. For more
Advertisement
Table of Contents
