Avaya 9601 Installing And Maintaining page 36

9600 Series IP Deskphones installation
Note:
The Ethernet speed indicated is the LAN interface speed for both the deskphone
Note:
and any attached PC, assuming the administrator has not disabled the latter
interface by a PHY2STAT setting.
!
Important:
Pressing the Program softkey at any time during startup invokes the Craft
Important:
Access entry procedure to allow manual settings, but only if the PROCSTAT
(local dialpad procedure status) system value is "0" providing full access to local
procedures or if PROCSTAT is "1" in certain instances requiring input. For
information, see
invoked, the startup process terminates. The Program softkey also displays in
conjunction with a message describing a processing conflict, for example, when
an ARP response indicates a conflict in obtaining the IP Address.
5. The deskphone sends a request to the DHCP server and invokes the DHCP process.
The following message displays:
DHCP: s secs
where s is the number of seconds that have elapsed since DHCP was invoked.
6. VLAN verification and tagging occur. The following message displays:
VLAN ID = n
where n is the VLAN ID being used.
7. Determination of the DHCP protocol (IPv4 is done, and the applicable parameters enabled.)
The DHCP server provides IP Addresses for the following hardware:
The 9601, 9608, 9608G, 9611G, 9621G, or 9641G IP deskphone
The HTTP/HTTPS server
The SIP Proxy server
8. Using the list of gateway IP Addresses provided by the DHCP server, the deskphone
performs a router check and verifies that the router is on the same subnet as the IP
Address. The deskphone cycles through the gateway IP Addresses with ARPs or pings until
it receives a response. When the router is located, received LLDP TLVs are processed.
Then the HTTP process starts.
Note:
Any change in VLAN-related configuration parameters resulting from LLDP
Note:
triggers a deskphone reset.
9. The HTTP process starts with an HTTP GET command, which displays on the deskphone's
Status Line.
36 SIP Deskphones Release 6.4 Installation and Maintenance Guide
Chapter 3: Local administrative options. If Craft procedures are