Christie DWU951 User Manual page 18

STACK menu settings
NOTE • The images projected from the Main and Sub projectors may be
different. It is recommended to set the projectors as follows.
- Set the same image for TEMPLATE and START UP on the Main and Sub
projectors.
- Capture the same image for My Screen on the Main and Sub projectors.
- Save the same image on MY IMAGE on the Main and Sub projectors.
- Set the same message content for the Messenger function (Network Guide
→ Messenger Function) on the Main and Sub projectors.
• Image shift can result in image quality degradation on the screen. Perform
the INSTALLATION setting before adjusting the image position as the image
position will change when the INSTALLATION setting is changed. (Operating
Guide → SETUP menu)
• When PIN LOCK on both projectors is set to ON (Operating Guide →
SECURITY menu), cancel the settings of the two projectors.
• When Intellectual Stack is in use, the POWER indicator on the projector
operates differently from normal. When both the Main and Sub projectors are
in standby mode, the Main projector determines which projector to turn on
according to the STACK MODE setting if the ON button on the remote control or
STANDBY/ON button of the Main projector is pressed.
- The POWER indicator on the Main projector blinks in green when the Sub
projector is going to turn on.
- If the Main projector is turned on, the POWER indicator on the Main projector
turns to steady green after lighting up, as per normal.
- If the Sub projector is turned on, the POWER indicator on the Main projector
lights in orange after the Sub projector is turned on.
- If an error occurs on the Main projector, the Sub projector turns on and the
POWER indicator on the Main projector lights or blinks in red.
DWU951/DHD951/DWX951/DXG1051 User's Manual - Instant Stack Guide
16
020-000663-02 Rev. 1 (06-2014)