For Simple Stack Users - Christie DWU951 User Manual

Installation

For Simple Stack users

1.
Press the MENU button on the remote control to display the menu on Set A.
2.
Use the ▲/▼/◄/► buttons to open the TEMPLATE
dialog, then select STACK on the dialog.
(Operating Guide → MENU PREFERENCES)
3.
Press the MENU button on the control panel of
Set B to display the menu.
4.
Use the ▲/▼/◄/► buttons to select 3D
KEYSTONE from EASY MENU, or the SETUP
menu of ADVANCED MENU. (Operating Guide
→ EASY MENU or SETUP menu)
3D KEYSTONE dialog appears on screen.
Set TEST PATTERN settings to ON to display the
test pattern.
5.
Using 3D KEYSTONE on Set B, adjust the image
size and position of Set B to superimpose well to the
image of Set A. It is recommended to adjust in the
following ways.
(1) Roughly adjust the four corners in the order below.
Top left → Top right → Bottom right → Bottom left
(2) Fine adjust the four corners in the same way.
NOTES for all users
of EASY MENU or SETUP menu in the Operating Guide.
• It is strongly recommended to use a flat screen. If a curved or skewed screen
is used, it is very difficult to align the two images even if you use the pin/barrel
adjustment of 3D KEYSTONE.
• Even through fine adjustment of the images from the two projectors, it may
not be possible to superimpose the images well enough depending on the input
signals. In this case, try the following methods.
- Press the AUTO button on the remote control or execute AUTO IMAGE
(Operating Guide → SIZE AND POSITION menu) on each of the projectors.
- Adjust H POSITION and V POSITION (Operating Guide → SIZE AND
POSITION menu) on each of the projectors.
- Check the RESOLUTION setting in the INPUT menu, and change to the same
setting if the setting differs between Main and Sub. (Operating Guide →
INPUT menu)
DWU951/DHD951/DWX951/DXG1051 User's Manual - Instant Stack Guide
• For details on 3D KEYSTONE, refer to 3D KEYSTONE
12
STACK of TEMPLATE
3D KEYSTONE dialog
on STACK of TEMPLATE
020-000663-02 Rev. 1 (06-2014)