Led Error Messages - Eiki EK-600U Owner's Manual

DLP Projector — Owner's Manual

lED Error Messages

The LED status indicators are located on the top of the projector. Each LED is defined below.
• power lED
LeD s
tatus
r
eD
Steady Light
Off
Off
Off
• Temp lED
LeD s
tatus
t (r )
emp eD
Flashing
Steady Light
• lamp lED
LeD s
tatus
L (r )
amp eD
Steady Light
b
Lue
Off Standby state (power cord connected).
Flashing Power is on (warming) or power is off (cooling).
(0.5 second
Note:
interval)
If the projector is in cooling state and the power LED turns red then it
indicates that the fan has turned off.
Flashing The projector is in Quick Resume mode and can be powered on again
(Flashing within a 100 seconds.
(0.25 second
interval)
Flashing Standby state, burnin (warning), or (burnin (cooling).
p (r )
oWer eD
Flashing Fan has failed and is in error state.
Flashing Over temperature. The projector will shut down.
p (r )
oWer eD
Flashing Lamp has failed and is in error state.
p
rojector
p
rojector
p
rojector
60
— —
s
tate
s
tate
s
tate