Image Problems; Lamp Problems - Eiki EK-600U Owner's Manual

Image problems

Problem: No image appears on the screen
1.
Verify the settings on your notebook or desktop PC.
2.
Turn off all equipment and power on again in the correct order.
Problem: The image is blurred
1.
Use the Focus lever to adjust the focus on the projector.
2.
Ensure the projector-to-screen distance is within the specified range.
3.
Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1.
Position the projector so it is as perpendicular to the screen as possible.
2.
Press the Keystone V button on the remote control or built-in keypad or manually adjust horizontal
keystone to correct the problem.
Problem: The image is reversed
Check the Rear projection on the Setup menu of the OSD.
Problem: The image is streaked
1.
Set the phase and Frequency settings on the picture > Signal (VGA input) menu of the OSD to the
default settings.
2.
Ensure the problem is not caused by a connected PC's video card, connect to another computer.
Problem: The image is flat with no contrast
Adjust the Contrast setting on the picture menu of the OSD.
Problem: The color of the projected image does not match the source image
Adjust the Color Temperature and Gamma settings on the picture > Advanced menu of the OSD.

lamp problems

Problem: There is no light from the projector
1.
Check that the power cable is securely connected.
2.
Ensure the power source is good by testing with another electrical device.
3.
Restart the projector in the correct order and check that the Lamp LED has not turned to red.
4.
If you have replaced the lamp recently, try resetting the lamp connections.
DLP Projector — Owner's Manual
61
— —