Led Error Messages - Eiki EK-800U Owner's Manual

LED Error Messages

The LED status indicators are located on the rear of the projector. Each LED is defined below.
• Lamp 1 LED
LeD s
tatus
g
reen
Flashing Flashing
Steady Light Steady Light
Steady Light Off
Flashing Off
Off Flashing
Off Flashing
• Lamp 2 LED
LeD s
tatus
g
reen
Steady Light Steady Light
Steady Light Off
Flashing Off
Off Flashing
Off Flashing
• Status LED
LeD s
tatus
g
reen
Steady Light Off
Flashing Flashing
Flashing Steady Light
Steady Light Steady Light
Off Steady Light
Off Flashing
Note:
If the system is over temperature, these Lamp1, Lamp2, and Status LEDs are Flashing RED Light at
the same time.
• Shutter LED
LeD s
tatus
Off
Flashing
r
eD
Color wheel unexpectedly stopped.
Lamp1 time has expired and lamp should be replaced.
Lamp1 is on and operating correctly.
Lamp1 is switching on.
Failed to strike lamp1 after 5 attempts (strike attempts will stop).
Lamp1 has unexpectedly shut down (system goes into cooling down
state).
r
eD
Lamp2 time has expired and lamp should be replaced.
Lamp2 is on and operating correctly.
Lamp2 is switching on.
Failed to strike lamp2 after 5 attempts (strike attempts will stop).
Lamp2 has unexpectedly shut down (system goes into cooling down
state).
r
eD
Projector is powered up and operating normally.
Projector is in cooling down mode or startup mode.
Projector is in flash update state.
Need to clean/change dust filter.
Power standby in Communication mode
Fan failure
(g )
reen
Picture mute is off and Shutter is Off – image is displayed.
Picture mute is on and Shutter is On – image is black.
DLP Projector — Owner's Manual
p
rojector
p
rojector
p
rojector
p
rojector
63
— —
s
tate
s
tate
s
tate
s
tate