Powering Off The Projector; Led Indicator Messages - Eiki EIP-WSS3100 Owner's Manual

Powering Off the Projector

1. Press the
the projector. The following message will be displayed on the screen.
Press the "
Power Off?
Press power key again.
2. The Power LED will turn red and blink rapidly after the projector is turned off.
And the fans will continue to operate for about 90 seconds to ensure that the
system cools properly.
3. Once the system has finished cooling, the Power LED will stop blinking and turn
solid red to indicate standby mode.
4. It is now safe to unplug the power cord.

LED Indicator Messages

Message
Power Plug
Standby
Power button ON
Cooling state
Power button OFF:
Cooling completed; Standby Mode
Firmware download
Thermal sensor error, OSD showing as
below:
1. Make sure air in and outlets are not
blocked.
2. Make sure the environment temperature
is under 40 degree C.
Fan lock error, OSD showing as below:
The projector will switch off automatically.
Lamp error (Lamp, Lamp driver, Color
wheel)
English ... 14
" " button on the control panel or on the remote control
" button again to confirm.
Lamp LED
Flash ON to OFF
Temp LED
(Red) (Red)
Flash ON to OFF
100ms 100ms
- -
- -
- -
- -
ON ON
- ON
0.5 second H(On),
- 0.5 second L(Off)
flashing
ON -
to turn off
Power LED Power LED
(Red) (Blue)
Flash ON to OFF
-
100ms
ON -
- ON
0.5 second H(ON),
0.5 second L(OFF) -
flashing
ON -
ON -
- ON
- ON
- ON