Communications Menu - Eiki EK-600U Owner's Manual

I
tem
Ethernet
RS232
HDBaseT Mode

Communications Menu

Press the Menu button to open the OSD menu. Press the arrow keys (pq) to select SETUp and press
the Enter button to enter the SETUp menu. Press the arrow keys (pq) to select Communications and
press the Enter button to enter the Communications menu. Press the arrow keys (pq) to select the
menu option and press the Enter button to enter its submenu. Press the arrow keys (pqtu) to select or
adjust the desired settings and press the Enter button to confirm.
I
tem
LAN
Control Settings
Reset
Enable or disable the Ethernet feature.
Enable or disable the RS232 feature.
Set the HDBaseT mode setting:
• Auto: The projector will automatically switch to the HDBaseT mode
when it detects a signal from the HDBaseT port.
• HDBaseT: The projector is switched to the HDBaseT mode.
SETUP
Communication
LAN
Control Settings
Reset
Configure the local area network (LAN) settings.
• Network Status: Display the network connection status (read-only).
• MAC Address: Display the network MAC Address value.
• DHCP: Turn the DHCP ON/OFF.
• IP Address: Assign Network IP Address.
• Subnet Mask: Assign Network Subnet Mask.
• Default Gateway: Assign Network Default Gateway.
• DNS: Display DNS number.
• Crestron: Use this function to select the network function (port: 41794).
For more information, please visit http://www.crestron.com and www.
crestron.com/getroomview.
• Extron: Use this function to select the network function (port: 2023).
• PJLink: Use this function to select the network function (port: 4352).
• AMX Device Discovery: Use this function to select the network function
(port: 1023).
• Telnet: Use this function to select the network function (port: 23).
• HTTP: Use this function to select the network function (port: 80).
Reset the Communication menu items to their factory defaults.
39
— —
DLP Projector — Owner's Manual
D
escrIptIon
Exit
D
escrIptIon