Cleaning The Projector; Cleaning The Lens - Eiki EK-600U Owner's Manual

4.
Slightly move the dust filter cover to the left and to the right direction to release it from the latches on the
case. And then remove.
5.
Install the new filter by reversing the previous steps.
Note:
Dust filters are only required/supplied in the selected regions with excessive dust.

Cleaning the projector

Cleaning the projector to remove dust and grime will help ensure trouble-free operation.
Warning:
• Be sure to turn off and unplug the projector at least 30 minutes before cleaning. Failure to do so
could result in a severe burn.
• Use only a dampened cloth when cleaning. Do not allow water to enter the ventilation openings on
the projector.
• If a little water gets into the projector interior while cleaning, leave unplugged in a well-ventilated
room for several hours before using.
• If a lot of water gets into the projector interior when cleaning, have the projector serviced.

Cleaning the Lens

You can purchase Optical lens cleaner from most camera stores. Refer to the following to clean the
projector lens.
1.
Apply a little Optical lens cleaner to a clean soft cloth. (Do not apply the cleaner directly to the lens.)
2.
Lightly wipe the lens in a circular motion.
Caution:
• Do not use abrasive cleaners or solvents.
• To prevent discoloration or fading, avoid getting cleaner on the projector case.
DLP Projector — Owner's Manual
57
— —