Led Error Messages - Eiki EK-800U Owner's Manual

DLP Projector — Owner's Manual

LED Error Messages

The LED status indicators are located on the rear of the projector. Each LED is defined below.
• Lamp 1 LED
LeD s
tatus
g
reen
Flashing
Steady Light
Steady Light
Flashing
Off
Off
• Lamp 2 LED
LeD s
tatus
g
reen
Steady Light
Steady Light
Flashing
Off
Off
• Status LED
LeD s
tatus
g
reen
Steady Light
Flashing
Flashing
Steady Light
Off
Off
• Shutter LED
LeD s
tatus
Off
Flashing
r
eD
Flashing Color wheel unexpectedly stopped.
Steady Light Lamp1 time has expired and lamp should be replaced.
Off Lamp1 is on and operating correctly.
Off Lamp1 is switching on.
Flashing Failed to strike lamp1 after 5 attempts (strike attempts will stop).
Flashing Lamp1 has unexpectedly shut down (system goes into cooling down
state).
r
eD
Steady Light Lamp2 time has expired and lamp should be replaced.
Off Lamp2 is on and operating correctly.
Off Lamp2 is switching on.
Flashing Failed to strike lamp2 after 5 attempts (strike attempts will stop).
Flashing Lamp2 has unexpectedly shut down (system goes into cooling down
state).
r
eD
Off Projector is powered up and operating normally.
Flashing Projector is in cooling down mode or startup mode.
Steady Light Projector is in flash update state.
Steady Light Need to clean/change dust filter.
Steady Light Over temperature.
Flashing Fan failure
(g )
reen
Picture mute is off and Shutter is Off – image is displayed.
Picture mute is on and Shutter is On – image is black.
p
rojector
p
rojector
p
rojector
p
rojector
56
— —
s
tate
s
tate
s
tate
s
tate