Hangar 9 toledo special 40 Assembly Manual page 21


Step 4
Insert the battery tray in the fuselage with the speed control
facing to the top of the fuselage. Make sure to guide the
wires for the motor through the hole in the firewall and the
wires for the battery and connection to the receiver are under
the battery tray support. Slide the tray rearward so it keys
into the former at the rear of the tray. The front of the tray
is secured using two 4-40 x 3/8-inch socket head screws
and two #4 washers. Use threadlock on the screws before
tightening them using a 3/32-inch hex wrench or ball driver.
hint: Use low-tack tape to keep the hook and loop strap
out of the way while installing the battery tray.
Hangar 9 Toledo Special Assembly Manual

Step 5
Plug the speed control lead into the throttle channel of the
receiver. Mount the switch from the E-Flite 60-amp ESC in
the switch location on the side of the fuselage in the battery
compartment.

Step 6
Secure the battery in the fuselage using the hook and
loop strap. It is suggested to use a piece of hook and loop
material (not included) between the battery and battery tray
to keep the battery from sliding on the battery tray in flight.

Step 7
Use a hobby knife and #11 blade to remove the covering
from the fuselage hatch so it can be removed easily to
access the battery. This will also provide an exit for air to
escape after entering the fuselage.
21