Window Installation - Hangar 9 toledo special 40 Assembly Manual


Step 9
Slide the propeller on the motor shaft. Align the propeller so
it almost touches the two small pegs that protrude from the
spinner backplate.

Step 10
Use the propeller nut (and washer) to secure the propeller
and spinner backplate. Make sure to use a box wrench when
tightening the propeller nut on a glow engine. Using pliers or
an adjustable wrench may slip and damage the nut.
Hangar 9 Toledo Special Assembly Manual

Step 11
Slide the spinner cone into position on the spinner backplate.
It will key into the grooves of the backplate. Make sure that
the propeller does not touch the spinner cone. If it does,
remove the cone and reposition the propeller in relation to
the backplate. Once the propeller is positioned, use two #4 x
1/2-inch sheet metal screws and a #1 Phillips screwdriver to
secure the spinner cone to the backplate.

Window Installation

Required Parts
Fuselage assembly Windshield
Center window (2)
Rear window (right and left)
Forward window (right and left)
Tools and Adhesives
Low-tack tape Canopy glue

Step 1
Locate the windows and windshield as listed in the parts.
All the windows are pre-trimmed and ready to mount in the
fuselage. The only thing that will take time is allowing for the
glue to cure.
25