Hangar 9 toledo special 40 Assembly Manual page 16

note: It may be necessary to rotate the carburetor to
match the photo below. Follow the instructions included
with youtr engine if repositioning the carburetor is
necessary.

Step 4
Use a drill and 5/32-inch (4mm) drill bit to drill a hole
through the firewall at the mark made in the previous step.
16

Step 5
Use medium grit sandpaper to scuff the outside of the
12-inch (305mm) pushrod tube. This will provide a better
surface for the CA to adhere to when gluing the tube in
position.

Step 6
Insert the throttle tube into the hole drilled in Step 4. Leave
roughly 1/8-inch (3mm) of the tube exposed so it will not
interferre with the operation of the throttle. Use medium CA
to glue the tube to the firewall.

Step 7
Position the engine on the mounts so the face of the drive
washer is 4 / -inches (114mm) forward of the firewall. Use
1
2
a pencil or drill bit to transfer the locations for the engine
mounting bolts onto the engine mounts. Use a clamp to hold
the position of the engine while marking the engine mount.

Step 8
Use a drill and 5/32-inch (4mm) drill bit to drill the holes for
the engine mounting screws in the engine mounts.
hint: If you have access to a drill press, it is highly
recommended that you use it. Using a drill press for
drilling these holes will guarantee they are straight.
Hangar 9 Toledo Special Assembly Manual