Hangar 9 toledo special 40 Assembly Manual page 22


Step 8
Place the fuselage hatch back onto the bottom of the
fuselage.

Step 9
Use a hobby knife with a #11 blade to remove the three
plugs in the firewall to allow air to pass into the fuselage.
22

Step 10
Use a drill and 5/32-inch drill bit to enlarge the outer holes
on the motor mount. Make sure to hold the mount securely
when drilling as it can be easily removed from your hand and
cause personal injury.
hint: It is highly recommended to use a drill press for
drilling the mount if one is available.

Step 11
Secure the mount to the motor using the hardware provided
with the motor. Use #2 Phillips screwdriver and threadlock
to secure the screws.

Step 12
Attach the motor to the firewall using four 8-32 x 2-1/4-inch
machine screws, four 1-15/16- (48mm) standoffs and four
#8 washers. Use threadlock on the screws to prevent them
from vibrating loose.

Step 13
Connect the leads from the motor to the leads from the
speed control. Use the radio system to operate the motor
and check its rotation. When viewed from the front of the
fuselage the motor will rotate counterclockwise. If not, follow
the instructions provided with the speed controller to correct
the direction of rotation. Use a tie-wrap (not included) to
secure the motor leads so they will not interfere with the
operation of the motor.
Hangar 9 Toledo Special Assembly Manual