Hangar 9 toledo special 40 Assembly Manual page 17


Step 9
Use four 8-32 x 1-inch machine screws, four #8 washers
and four 8-32 lock nuts to secure your engine to the mounts.
Use a #2 Phillips screwdriver and 11/32-inch box wrench or
nut driver to tighten the hardware.

Step 10
Use side cutters to trim the pushrod tube at the forward end
of the servo as shown.
Hangar 9 Toledo Special Assembly Manual

Step 11
Slide one of the plywood throttle tube supports on the
throttle tube as shown. Two supports have been provided,
but only one is necessary to support the throttle tube near
the servo.

Step 12
Use side cutters to remove one of the arms from a
180-degree servo horn.

Step 13
Center the throttle stick and trim. Secure the servo horn to
the throttle servo using the screw provided with the servo
using a #1 Phillips screwdriver. Attaching the horn using this
method will give equal movement of the horn to both low
throttle and full throttle.

Step 14
Open the bag marked fuselage. Remove the clevis retainer
and slide it onto the clevis from the bag. The clevis is then
threaded 10 turns on the 16 / -inch (420mm) pushrod.
1
2

Step 15
Slide the pushrod into the pushrod tube. Connect the clevis
to the hole of the servo arm that is 1/2-inch (12mm) from
the center of the servo horn. Use the radio system to move
the throttle to the low position.
17