Inch (6Mm) Fuel - Hangar 9 toledo special 40 Assembly Manual

24

Step 6
Prepare the four 4-40 x 1/2-inch socket head screws for
installation by sliding a #4 washer and a piece of 1/4-inch
(6mm) fuel tubing on each screw as shown.

Step 7
Use the screws prepared in the previous step and a
3/32-inch ball driver or hex wrench to attach the cowl
to the fuselage.

Step 8
Slide the spinner backplate onto the shaft of your motor. It
may be necessary to use a reamer to enlarge the hole in the
spinner to fit your shaft.
note: If you are using an electric motor, you will
need to install the propeller adapter first. Follow the
instructions included with the motor for the installation
procedure for the adapter.
note: It may be necessary to enlarge the hole in the
spinner backpolate to fit you motor or engine. Use a
metric propeller reamer for this job.
Hangar 9 Toledo Special Assembly Manual