Touch Pad / Touchscreen (Only For Models With Touchscreen) - Panasonic CF-29 Series Reference Manual

Dealing with Problems (Advanced)
Disk Operations
Unable to read/write to the hard disk

Touch Pad / Touchscreen (only for models with touchscreen)

The cursor cannot be controlled
properly
The cursor does not move in scrolling
area of the touch pad
Unable to input using the touch pad
Unable to point correctly with the sty-
lus included with the computer
Unable to input by touching the display
Sound
The sound is not heard
Volume does not change when
Fn+F5 or Fn+F6 is pressed
Your drive or file may not have been properly set.
Check to see if the hard disk is full. If it is full, delete unnecessary files.
Your hard disk content may be corrupted. Contact Panasonic Technical
Support.
If you are using an external mouse, ensure that the external mouse has been
connected correctly.
Restart the computer by using the keyboard.
, U, and select [Restart] with
(Press
If the computer does not respond to keyboard commands, read "No response"
( page 114).
®
When the Microsoft IntelliMouse™ Wheel mode or the original mode is set for
the touch pad, only scroll operations are possible for the right part or bottom
part of the touch pad. In this case, cursor operations are possible by using the
work surface excluding the right part or bottom part. When no mode is set, the
entire surface of the touch pad can be used for cursor operations.
Has the Setup Utility been used to set [Touch Pad] to [Enable]?
When external mouse drivers are installed (e.g., Intellimouse), the touch pad
may not be used.
Has the touch pad driver been properly installed?
As a result of the physical characteristics of the Touchscreen, sometimes the
position of the stylus does not match the position of the cursor on the screen.
This is not a malfunction. Perform [Calibration]. (
Has the Setup Utility been used to set [Touchscreen] to [Enable]?
When mouse drivers are installed (i.e. IntelliMouse), the touchscreen is unable
to be used.
Has the touchscreen driver been properly installed?
Try changing the mute by pressing Fn+F4 or Fn+F6.
If the Windows sound function is not active, the volume will not change even if
is displayed.
113
, then press Enter.)

page 26)