Panasonic CF-29 Series Reference Manual page 111

Dealing with Problems (Advanced)
Connecting Peripherals
USB floppy disk drives do not work as
a boot drive
You do not know the available RAM
module
Cannot tell whether the RAM module
has been correctly installed
The RAM module has not been
recognized
The address map for IRQ, I/O port
address, etc. is unclear
Unable to print
Only the Panasonic CF-VFDU03 USB floppy disk drive (optional) can be used.
Make sure [Floppy Operation], [Legacy USB Support] and [Legacy USB Floppy]
are set to [Enable] in the Setup Utility.
After powering off the computer, connect the USB floppy disk drive and restart
the computer.
Remove the floppy disk drive that is inserted inside the multimedia pocket or
connected to the parallel port.
page 63
You can check whether the RAM module is recognized using [Information]
menu in the Setup Utility. If the RAM module is not recognized, turn the
computer off and reinsert the RAM module.
Make sure the RAM module has been properly inserted.
Use the RAM module that supports the recommended specifications (
63).
The current address map can be displayed with the following procedure.
Windows XP
[Start] - [Control Panel] - [Performance and Maintenance] - [System] -
[Hardware] - [Device Manager] - [View] - [Resources by type].
Windows 2000
[Start] - [Settings] - [Control Panel] - [System] - [Hardware] - [Device Manager] -
[View] - [Resources by type].
Check the computer-printer connection.
Make sure the printer is on.
Make sure the printer is in the online state.
Make sure paper is in the printer tray and there is no paper jam.
Has the Setup Utility been used to set [Parallel Port] to [Enable] or [Auto].
Depending on the printer, EPP or ECP may not work at times.
111
page