List Of Error Code - Panasonic CF-29 Series Reference Manual

List of Error Code

When turning on the computer, if one of the following error codes or messages is displayed,
follow the instructions shown below.
If the problem persists, or if the error code or message displayed is not shown here, contact
Panasonic Technical Support.
Error Code/Message
Invalid system disk.
Replace the disk, and then press
any key
0200: Failure Fixed Disk
0211: Keyboard error
0251: System CMOS checksum bad
- Default configuration used
0271: Check date and time settings
Action
If a floppy disk is set in the floppy disk drive,
remove the disk and press any key.
If a device is connected to the USB port, discon-
nect the device, or run the Setup Utility and set
[Legacy USB Support] in [Security] menu to [Dis-
able].
Disconnect the hard disk drive and reconnect it
again. Make sure the drive is secured correctly.
If the second hard disk drive is inserted inside
the multimedia pocket, remove the drive and
reconnect it. Make sure the drive is secured
correctly.
If an external keyboard or mouse is connected,
disconnect these devices.
An error has occurred in the memory that stores the
Setup Utility settings. This error occurs when the
memory content is changed through some inadvert-
ent operation by a program or other function.
Run the Setup Utility and load the default values,
then change the settings to the appropriate
values as needed.
If the problem persists, the internal clock battery
may need to be replaced. Contact Panasonic
Technical Support.
The data and time setting are incorrect.
Run the Setup Utility and set the date and time
correctly.
If the problem persists, the internal clock battery
may need to be replaced. Contact Panasonic
Technical Support.
101