Led Indicators - Panasonic CF-29 Series Reference Manual

LED Indicators

Power status
Battery pack status
Not lit
Power off / Hibernation mode
Green
Power on
Blinking green
Standby mode
Not lit
Battery pack is not connected or charging not being performed.
*1
Orange
Charging in progress.
*1
Green
Fully-charged.
Blinking green
In high temperature mode, the battery pack is discharging to a level of
*2
80% in normal temperature mode. Do not remove the battery pack while
the battery indicator is blinking green.
Red
The battery level is very low (the charge is less than approx. 9% capacity).
Connect the AC adaptor. You can use the computer when the battery
indicator light is orange. If you do not have an AC adaptor, save your data
and power off your computer. After replacing the battery pack with a fully
charged one, turn your computer on.
*1
Blinking red
Battery pack or charging may not be working properly. Quickly save your
data and power off your computer. Remove the battery pack and
disconnect the AC adaptor, then connect them again. If the problem
persists, contact Panasonic Technical Support. Possible failure in the
battery pack or charging circuit.
*1
Blinking orange
Battery cannot be recharged temporarily because the internal temperature
of the battery pack is outside of the acceptable temperature range for
recharging. Once the allowable range requirement is satisfied, charging
begins automatically. Your computer can be used normally in this state.
Blinking green and orange alternately
Warming up the system to prevent hard disk drive malfunctions at low
temperature. Leave your computer as is. Once the allowable range
requirement is satisfied, your computer will start automatically.
10