Panasonic CF-29 Series Reference Manual page 104

Dealing with Problems (Advanced)
Starting Up
When resuming from the standby or
hibernation mode, [Enter Password]
does not appear even if a password
has been set in the Setup Utility
When the administrator password is
forgotten
Even when a password has been set in the Setup Utility, [Enter Password] does
not appear when the computer resumes from the standby or hibernation mode.
If you want to use the security function when using the standby or hibernation
mode, use the Windows password as follows:
Windows XP
Select the account to change in [Start] - [Control Panel] - [User Accounts] and
set the password, then add the check mark for [Prompt for password when
computer resumes from standby] in [Control Panel] - [Performance and
Maintenance] - [Power Options] - [Advanced].
Windows 2000
Set the password in [Start] - [Settings] - [Control Panel] - [Users and
Passwords], then add the check mark for [Prompt for password when computer
goes off standby] in [Control Panel] - [Power Options] - [Advanced].
Set the password again in the following procedure.
Windows XP
If you have created a password reset disk (⇒ Operating Instructions "First-time
Operation"), a message is displayed when you fail to correctly enter the
password. Follow the message's instructions and set the password again by
using the password reset disk.
If you have not created a password reset disk, after reinstalling, setup Windows
and then set the password again.
Windows 2000
After reinstalling, setup Windows and then set the password again.
104