Error Code/Message - Panasonic CF-51JB0DCBM User Manual

Error Code/Message

Follow the instructions below when an error message or code appears. If the problem persists or if the error code/mes-
sage is not shown here, contact Panasonic Technical Support (
Error Code/Message
0211 Keyboard error
0251 System CMOS
checksum bad -
Default configuration
used
0271 Check date and
time settings
0280 Previous boot
incomplete - Default
configuration used
Press <F2> to Setup
Operating System not
found
RAM Module Failed
To start the Setup Utility
A Restart the computer.
B Press F2 several times while [Panasonic] boot screen is displayed soon after the computer begins the startup
procedure.
Disconnect external keyboard or mouse.
An error has occurred in the memory of Setup Utility settings. This occurs when the memory
content is changed by an unexpected program operation, etc.
Start the Setup Utility and return the settings to the default values, and then change the
settings as necessary.
If the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support (
The date and time settings are not correct.
Start the Setup Utility and set the correct date and time.
If the problem persists, the internal clock battery may need to be replaced. Contact
Panasonic Technical Support (
Startup has failed repeatedly, so the Setup Utility settings have been returned to the default
values to startup the computer.
Start the Setup Utility and return the settings to the default values, and then change the
settings as necessary.
Write down the error details and press F2 to start the Setup Utility. Change the settings if
necessary.
The operating system is not installed in the floppy disk or the hard disk that you are going to
boot from.
If using a floppy disk, change the disk to the one you can use for boot.
If using the hard disk, check if the hard disk is recognized in [Information] menu of the
Setup Utility. If the hard disk is recognized, perform the reinstallation (
contact Panasonic Technical Support (
If a device is connected to the USB port, disconnect the device, or set [USB Port] or
[Legacy USB Support] to [Disable] in [Advanced] menu of the Setup Utility.
When the RAM module is not inserted correctly or the RAM module is not conforming to the
computer's specifications, so a beep will sound and the "RAM Module Failed" message will
be displayed when you turn the power on.
Press the power button for four seconds or longer to turn off the computer, confirm that
the RAM module conforms to the specifications, and reinsert it.
page 29).
Solution
page 29).
page 29).
page 29).
page 17). If not,
19