Sequence Setup Section - AngelTrax ATCF460 MDVR Quick Setup Manual

Peripheral Setup (Cont.)
Sequence Setup
1. From the Peripheral Setup menu, use the arrow buttons on
the remote to select Sequence Setup (see Figure 6), and
press ENTER.
2. At the Full Screen option under the Sequence Setup menu,
press the plus or minus buttons on the remote to adjust
the length of time the Sequence mode will rotate out each
camera (channel) view in Full Screen mode. The length of
time ranges from one to 60 seconds (see Figure 7).
3. The Sequence button can be found on the top right side of
the remote (see Figure 8). Press this button while in Quad or
Pop view to review each channel in Full Screen mode on a
continuous loop.
Press the Stop or Sequence buttons on the remote to stop
4.
the loop on one channel. Press the Sequence button again
to restart the loop. Press the Quad or Pop buttons (located
above the numbered buttons at the bottom of the remote -
see Figure 9) while in Sequence Setup mode to return to the
standard view.
The Pop button on the remote is used to change the
5.
monitor display to show one channel larger than the others
simultaneously. Use the plus and minus buttons on the
remote to change the channel view.
6. The Quad button on the remote is used to display the
channel views in four equal windows.
To save your changes and return to the Peripheral Setup
7.
menu, press the Menu button on the remote.
AngelTrax | 38
MENU ZOOM SEQUENCE
ENTER COPY
REWIND PLAY PAUSE
REWIND PLAY PAUSE
AUDIO POP QUAD
AUDIO POP
CAM1 CAM2 CAM3 CAM4
CAM1 CAM2 CAM3
CAM5 CAM6 CAM7
6
7
8
STOP
STOP
9
QUAD
CAM4
CAM8