Panic Button Connection Section; Panic Button Versions Diagram - AngelTrax ATCF460 MDVR Quick Setup Manual

Panic Button Connection
The external signal button (or panic button), can be connected to show DVR status without using a video monitor. This button has the
following functions when installed: Power indicator LED (red), Record indicator LED (amber), GPS signal indicator LED (green) and event
marker (panic button), to cause an alarm event to be recorded by the DVR.
1. Determine the proper location before drilling the mounting
hole. The vehicle's control panel should be easily accessible
to the driver.
2. Drill a 1.125" hole in the desired location (see Figure 1).
Ensure the area behind the hole is clear of obstructions
before drilling.
3. Feed the connector and cable through the mounting hole
and attach the panic button (see Figure 2).
4. Put the panic button into the hole.
Panic Button Ring Color
Flashing amber light
Green light (blinks until locking
in to the GPS signal, then
becomes solid)
Red light (blinks intermittently)
Panic Button Versions
There are three versions of the panic event button, each outlined below:
Panic Button
Version 1
Event Marker Button
GPS Signal Indicator
(red)
Power Indicator
(green)
Recording Indicator
(amber)
AngelTrax | 11
The DVR is recording
GPS signal indicator
The DVR is powered up
Panic Button
Version 2
Event Marker Button
Power Indicator
(red)
GPS Signal Indicator
(green)
Recording Indicator
(amber)
1.125 in
Panic Button
PANIC BUTTON
{ mounting surface }
Panic Button Mounting Surface
Panic Button
Version 3*
Event Marker Button
Power Indicator
GPS Signal Indicator
Recording Indicator
(*all indicators red)
1
2