Table of Contents
Advertisement
Record Setup
CAUTION: It is not suggested that the following settings be adjusted. Settings should be left at their
factory default. Altering these values could result in poor or inaccurate performance.
From the Main Menu list, select the Record Setup option (see
Figure 1) using the arrow buttons on the remote, and
press ENTER.
There are four settings under the Record Setup menu that can
be adjusted. Settings include: Record Mode, Continuous Record,
Alarm Record and Motion Record.
Record Mode
Select Record Mode from the Record Setup menu (see
1.
Figure 2) by pressing ENTER on the remote.
2.
Record Mode settings include:
•
C - Continuous Record: The system will record all
channels continuously while the vehicle is running.
A - Alarm Record: The system will boot and record when
•
an alarm has been triggered.
•
M - Motion Record: The system will boot and record when
the cameras detect motion while the vehicle is running.
3.
Refer to the Motion Detection Section, page 27, for
instructions on how to setup your cameras for the Motion
Detection function.
4.
The default Record Mode setting is Continuous. To change
the setting to Alarm, Motion or a combination of the three
settings, select each letter under the AM/PM timeline
(see Figure 3), and press the plus or minus buttons on the
remote to change each letter.
5.
Depending on your application, you can alternate or
combine any of the three settings (Motion, Alarm and
Continuous), throughout the day.
To save your changes and return to the Record Setup menu,
6.
press the Menu button on the remote.
AngelTrax | 32
1
2
3
Hide quick links:
Advertisement
Table of Contents
