Table of Contents
Advertisement
Camera Setup (Cont.)
Motion Detection
CAUTION - MOTION DETECTION:
Using motion detection is not typical of mobile digital
video recorders. However, it can be utilized when you
need to conserve recording space.
The Motion Detection feature is a CAMERA MOTION DETECTION
feature only. This setting will not activate Motion Record. It is only
for camera preparation (to set the system to Motion Record, see
the Motion Record Section, page 35).
1.
From the Main Menu, navigate to the Camera Setup option
using the arrow buttons, and press ENTER. Select the
Motion Detection option (see Figure 6) using the arrow
buttons on the remote, and press ENTER.
In the Area Setting option of the Motion Detection menu, a
2.
specific area of the camera view to activate recording when
motion is detected may be designated, or you may leave
the setting as-is and the entire camera view will activate
recording when motion is detected.
3.
To designate a specific area of the camera view, select a
camera number using the plus or minus buttons on the
remote (see Figure 7).
4.
Select Run by pressing the ENTER button on the remote.
5.
A grid will appear over the selected camera area. Use the
arrow buttons on the remote to navigate through the grid
square by square. To designate a square of the camera view
as 'active,' press the plus button on the remote. The square
will turn blue, which indicates the area is now 'active.' You
may continue to activate squares by pressing the plus
button (see Figure 8).
6.
If you press the ENTER button on the remote while in the
grid view, all the squares will activate. Press the ENTER
button again, and all the squares will deactivate.
7.
Press the Menu button on the remote to save your changes
and return to the Motion Detection screen.
AngelTrax | 27
6
7
8
Hide quick links:
Advertisement
Table of Contents
