Busy Override And Camp-On Ring Tone Over Handset/Headset Option; External Power Straps - Toshiba STRATA CTX100 Installation And Maintenance Manual

Busy Override and Camp-on Ring Tone Over Handset/Headset
Option
Busy override and camp-on ring tones can be sent over the DKT handset or headset, in addition to
the speaker.
➤
To send busy override/camp-on ring tones over the handset of the DKT2010-H model
1. Loosen the four captive screws on the telephone base
2. Install a strap in the HS-BOV W409 location (see
3. Reinstall the telephone base.
➤
To send busy override/camp-on ring tones over the handset/headset of the DKT2010-SD/
2020-S/2020-SD
➤
Hold down the
➤
To block the tone over the handset/headset of the DKT2010-SD/2020-S/2020-SD
➤
Hold down the
Note For this to function properly with headsets, make sure the speaker OCA strap or R607
is cut on the HHEU PCB and the HHEU strap is cut on the telephone. (See
8-32,

External Power Straps

Digital telephones equipped with options such as integrated data interface units and ADMs require
two-pair wiring or external power to operate efficiently at the maximum-allowed distance from the
KSU. Two-pair wiring or external power is also necessary for maximum cable run lengths for
digital telephones that are connected to systems that must operate with reserve power (see
3 – Strata CTX670 Installation
Each digital telephone has two external power straps which must be cut for external power when
the cabling of the telephone is connected to an external AC/DC power supply.
➤
To cut the straps
See Figures 8-24
1. Loosen the four captive screws on the telephone base and remove the base.
2. Depending on the telephone, locate the W101 and W102 external power straps and cut them.
3. Reinstall the telephone base, and secure it with its four captive screws.
Note Refer to Chapter 7 – MDF PCB Wiring
information and installation instructions.
Strata CTX I&M 10/02
5HGLDO
button and press the
5HGLDO
button and press the
8-34 and 8-35).
for more information).
and 8-34~8-35 and follow these steps:
(Figure 8-24), and remove the base.
Figure 8-34).
▲ button.
9RO
▼ button.
9RO
for external AC/DC power supply ordering
Station Apparatus
2000-series Telephones
Figures
Chapter
8-41