Ctx100 License Control; Licensed Software Options - Toshiba STRATA CTX100 Installation And Maintenance Manual

Strata CTX Configuration

CTX100 License Control

CTX100 License Control
The system size and feature capability is controlled using a software License Key Code. This key
code is obtained from Toshiba Internet FYI during the ordering process and is installed onto the
system processor via Strata CTX WinAdmin. Processor license codes activate system hardware
capacities in the following increments.
• The first 32 line/station ports do not require a license. Each additional set of four line/station
ports requires one LIC100-4 PORTS license (maximum of 112 ports).
• The optional DTMF receiver circuit (ARCS) provides 16 DTMF receiver hardware circuits and
16 ABR circuits. The first four DTMF circuits and all ABR circuits do not require a license.
Each additional set of four DTMF receiver circuits requires one LIC100-4DTMF license
(maximum of 16 DTMF circuits).
DTMF tone receiver circuits are required for standard telephones, Voice Mail DTMF
Note
integration, Tie, DID and DNIS line service.
• The optional RS-232 serial port interface (BSIS) provides two circuits to interface with SMDI
or Toshiba Proprietary Voice Mail integration, Call Accounting SMDR, and two for future
applications. The first circuit does not require a license, but circuits two through four each
require one LIC100-SER PORT license.

Licensed Software Options

Some software options are activated with license codes. The following software options require a
license:
• Each CTX system (node) in a Strata Net QSIG Network requires one LIC100-QSIG NET
license. A maximum of four serial network nodes are allowed in any one serial chain in the
network topology.
• The optional AETS PCB provides hardware LAN interface for all CTI Open Architecture
applications. Each individual CTI Open Architecture application requires one LIC100-
CSTA AP license (maximum nine).
1-4
Strata CTX I&M 10/02