Tapi And Simultaneous Voice And Data Upgrades For 3000-Series Telephones (Bpci) - Toshiba STRATA CTX100 Installation And Maintenance Manual

Station Apparatus
3000-series Telephone Option PCBs
TAPI and Simultaneous Voice and Data Upgrades for 3000-
series Telephones (BPCI)
Digital telephones can be upgraded with a Personal Computer Interface (PCI) to provide desktop
interface with the telephone and PC USB port. The PC connected to the BPCI can place telephone
calls, receive Caller ID, ANI, and DNIS information. The BPCI is compatible with Microsoft
TAPI application programs.
BPCI Installation
1. Loosen the four captive screws on the digital telephone base to remove it. Knock out the plastic
cover on the telephone base to provide access to the BPCI USB port. See
2. Refer to
3. Insert the three integrated unit wire plugs into connectors P1, P2 and P6 on the PCB in the
telephone. Make sure that the red wire is positioned as shown. (P1-P1, P2-P2, P6-P4.
Digital
Telephone
Top Assembly
Figure 8-10 BPCI Installation
4. Stick the USB label onto the base, just below the modular
cord port (see
Important!
BPCI requires a DKT3000-series telephone set in the
•
DKT3000 mode (see
8-17).
The BPCI also requires that the DKT3000-series
•
telephone be connected to a BDKU or BDKS PCB set to
the "BDKU" mode (not the "PDKU" mode). BPCI will
not function on a telephone connected to a PDKU or
RDSU PCB.
8-10
Figure 8-10 and install the BPCI inside the phone base. Secure with screws.
Red
(P4)
Wire
(P6) PCI/VSU
Figure 8-11).
"DKT2000 Mode On/Off" on page
(P2) PCI/VSU
(P1) PCI/ADM
BPCI
(P1)
(P2)
Install
5608
Two Screws
Figure 8-10.
PC USB
Connection
Port (knock out
plastic cover
on telephone
base)
Slide BPCI
under tabs on
the telephone base
Digital
Telephone Base
USB Label
Figure 8-11 USB Label
Strata CTX I&M
6035
10/02