L2Tp Connection - peplink ONE 20 User Manual

USER MANUAL
Peplink Balance Series

14.2.4 L2TP Connection

L2TP has all the compatibility and convenience of PPTP with greater security. Combine
this with IPsec for a good balance between ease of use and security.
L2TP User
Enter the required information in these fields in order to connect via L2TP to your ISP.
Name /
The parameter values are determined by and can be obtained from your ISP.
Password
Confirm L2TP
Verify your password by entering it again in this field.
Password
Server IP
L2TP server address is a parameter which is provided by your ISP.
Address / Host
Note: Leave this field blank unless it is provided by your ISP.
Your ISP will also indicate whether the server IP address is Dynamic or Static. Please click
Address Type
the appropriate value.
Each ISP may provide a set of DNS servers for DNS lookups. This setting specifies the
DNS (Domain Name System) servers to be used when a DNS lookup is routed through this
connection.
Selecting Obtain DNS server address automatically results in the DNS servers assigned
DNS Servers
by the PPPoE server to be used for outbound DNS lookups over the WAN connection.
(The DNS servers are obtained along with the WAN IP address assigned from the PPPoE
server.)
When Use the following DNS server address(es) is selected, you can enter custom DNS
server addresses for this WAN connection into the DNS server 1 and DNS server 2 fields.
http://www.peplink.com
L2TP Settings
-102 / 269 - Copyright © 2016 Peplink