Test Pattern - Eiki EK-100W Owner's Manual

Power management
For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not operated for a certain period. Select
one of the following options:
Ready
When the lamp has been fully cooled down, the
POWER indicator changes to green blinking. In this
condition, the projection lamp will be turned on if
the input signal is reconnected or any button on the
remote control or top control is pressed.
Shut down
When the lamp has been fully cooled down, the power
will be turned off.
Off
Power management function is off.
Timer
If the input signal is interrupted and no button is
pressed for more than 30 seconds, the timer display
with No signal appears. It starts the countdown until
the lamp is turned off. Press  button to set the
Timer(1~30min.)
Ready countdown
Set the time that ready status transfers to standby
status automatically.(0-30min. 0 Min: not transfer
automatically)
In ready status, press POWER button to switch to
standby status, and press any other button to turn on
the projector.
Filter counter
This function is used to set a frequency for filter
cleaning.
When the projector reached a specified time
between cleanings, a Filter warning icon
appears on the screen, notifying the cleaning
is necessary. After cleaning the filter, be sure
to select RESET and set the timer. The Filter
warning icon will not turn off until the filter
counter is reset.
Filter counter
Display the using time of the filter.
Timer
Set the time to displaythe warning icon.
Filter counter reset
Reset the filter counter.
48
Expand
Power management
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter

Test pattern

Network
Factory default
Lamp counter
No signal
01 : 20
Time left before Lamp is off.
Note:
Factory default: "Timer: 5 min",
"Ready countdown: 5 min".
Filter counter
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter
Test Pattern
This function is used to set the internal test
signal: Gray scale 1, Gray scale 2, Gray scale
3, Gray scale 4, Color bar, Red, Green, Blue,
Cross hatch, White, Black and Raster gray.
When you get into the Test Pattern mode,
press MENU to get back the selection page of
Test Pattern.
Network
Function : PC controls projector via LAN.
Preparation:
1. Equipments: PC, projector, cables
2. Connection procedures:
Connect the projector to routers or switches of the LAN by direct or cross cable. If it fails to
connect PC and projector by parallel cable, please switch to cross cable as suggested.
3. After the computer is booted and the projector is plugged in, indicator lights of LAN interface
on will flash continuously.
Operation procedures:
1 Turn on the projector.
2 Obtain network address. DHCP set is displayed as On and obtain network address
automatically.( If familiar with network, you can set DHCP as Off and obtain network
address manually.)
3 Enter network settings menu.
(1) Press MENU button on the remote control to
display screen menu. Press  button to
select Expand, then press the OK button.
(2) Press  button to select Network, and
then press the OK button to enter the network
menu.
MAC address ... Displays the MAC address
of wired network of this
projector.
IP address .........Displays the IP address of
wired network of this
projector.
Expand
Test Pattern
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter
Expend
Language
Auto setup
Keystone
Logo
Security
Power management
Filter counter
Test pattern
Network
Factory default
Lamp counter
LAN
Network setting
DHCP On
IP address
Subnet
Gateway
DNS
Set
Cancel
Adjust Select Back
Esc
ENTER
49