Connecting The Ac Power Cord; Basic Operation; Turn On The Projector - Eiki EK-306U Owner's Manual

Connecting the AC power cord

This projector uses nominal input voltages of
100–240V AC and it automatically applies to
different input voltages. It is designed to work
with a single-phase power system having a
grounded neutral conductor. To reduce the risk
of electrical shock, do not plug into any other
type of power system. If you are not sure of
the type of power being supplied, consult the
authorized dealer or service station. Connect
the projector with all peripheral equipment
before turning it on.
Note:
The AC outlet should be near this equipment
and must be easily accessible.
 Note:
For safety, unplug the AC power cord when the projector is not in use. When the projector is
connected to an outlet with AC power cord, it is in stand-by mode and consumes a little electric
power.
Note on the power cord
AC power cord must meet the requirements of the country where you use the projector. Confirm the AC
plug type with the chart below and proper AC power cord must be used. If the supplied AC power cord
does not match the AC outlet, contact the sales dealer.
Projector side
For the U.S.A. and
Canada
Ground
To the AC outlet.
To power cord
connector on the
projector.
Note:
● Using incorrect power cord may influence the product performance, or even cause hazards like an
electric shock or fire. To ensure the product performance and security, please apply the cable of the
same model with the original one.
20
Installation
Connect the AC power cord
(supplied) to the projector.
AC outlet side
For Continental
For the U.K.
Europe
To the AC outlet.
To the AC outlet.

Turn on the projector

1. Complete peripheral connections (with a
computer, video,etc.) before turning on the
projector.
2. Connect the projector's AC power cord into
the AC outlet. The POWER indicator turns
red.
3. Press the POWER button on the top control
or on the remote control. The POWER
indicator becomes green and the cooling
fans start to work. The preparation display
appears on the screen.
4. If the projector is locked with a PIN code, a
PIN code input dialog box appears. Enter
the PIN code as instructed below.
 Note:
● When the logo select is set to be "Off", the
logo will not be displayed on the screen.(See
page 47)
Enter a PIN code
Press the OK button, press ◄► button to
select a number and press the OK button to
enter it to the PIN code box, then number
changes to "*", automatically move the cursor
to next box. If you fixed an incorrect number,
press MENU button to reset it again.
Repeat the steps to complete entering a three-
digit number.
After entering the three-digit number,
Ground automatically move the cursor to "Set", press
the OK button then you can start to operate the
projector.
If you entered an incorrect "PIN code", the
number (***) turn red. PIN code will be reset
within one second automatically, Enter the
correct PIN code all over again.
What is PIN code?
PIN (Personal Identification Number) code is a
security code that allows the person who knows
it to operate the projector. Setting the PIN code
can prevent unauthorized use of the projector.
A PIN code consists of a three-digit number.
Refer to the PIN code lock function in the
"Expand" "Security" menu on page 48 for PIN
code lock operation of the projector.

Basic operation

16
PIN Code
----- Input PIN code
OK
PIN Code
*
Move Select
OK
Move the cursor to "Set", and press "OK".
Caution on handling the PIN code
If you forget the PIN code, the
projector can no longer be started.
Take a special care in setting a
new PIN code. Write down the
number in a column on page 82 of
this manual and keep it properly.
Should the PIN code be missing
or forgotten, consult the dealer or
service center.
Back
MENU
Back
MENU
21