Starting And Shutting Down The Projector; Turn The Projector On; Turn The Projector Off - Eiki EK-620UA Owner's Manual

DLP Projector — Owner's Manual

Starting and Shutting down the Projector

Turn the Projector On
1.
Connect the power cord to the projector. Then connect the other end to a wall outlet.
The Power button on the built in keypad is illuminated.
Important:
Make sure that the Power switch is in the ON position.
2.
Turn on the connected devices.
3.
Turn on the projector by pressing "
or press " " on the built-in keypad. The Status LED is
Orange with a long blink.
The projector splash screen displays and connected
devices are detected.
4.
If more than one input device is connected, press the Source key on the remote control to select an
input source (VGA, HDMI, HDBaseT, or DVI).
5.
The projector detects the source you selected and displays the image.
Turn the Projector Off
1.
Press " " on the built-in keypad or press "
message will appear on the displayed image.
2.
Press " " on the built-in keypad or press "
you do not press "
Caution:
Do not unplug the power cord until all of fans are stop–indicating the projector has cooled down.
" on the remote control
" or " " again, the warning message will disappear after 10 seconds.
" on the remote control to turn off the projector. A warning
" on the remote control again to confirm your selection. If
12
— —