Installing The Switch - Seagull Models ERCOUPE Assembly Manual

Nose Retractable servo arm.

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
side, in the fuselage.
www.seagullmodels.com
Throttle servo arm.
3/ 32" Hole.
Trim and cut.
Switch
INSTALLING THE STOPPER ASSEMBLY.
1) Using a modeling knife, carefully cut
off the rear portion of one of the 3 nylon tubes
leaving 1/2" protruding from the rear of the
stopper. This will be the fuel pick up tube.
2) Using a modeling knife, cut one length
of silicon fuel line. Connect one end of the line
to the weighted fuel pick up and the other end
to the nylon pick up tube.
Vent tube.
Fuel fill tube.
Fuel pick up tube.
5