Table of Contents
Advertisement
ERCOUPE
Position the Control horn on the Aileron and
use 30-minute Epoxy
Epoxy.
Elevator control horn.
INSTALL RUDDER CONTROL HORN.
Repeat steps to install the rudder control horn
as same as steps done for ailerons.
Fiberglass control horn
Epoxy.
4
Instruction Manual.
Rudder control horn.
INSTALLING THE FUSELAGE SERVOS.
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
vided with your radio system.
.
THROTTLE SERVO ARM INSTALLATION.
Install adjustable servo connector in the servo
arm as same as picture below:
Loctite secure.
1 PCS.
Because the size of servos differ, you
1) Install the rubber grommets and brass
2) Secure the servos with the screws pro-
Nose Retractable servo.
Throttle servo.
Adjustable Servo
connector.
Servo arm.
Advertisement
Table of Contents
