Reader Params - Motorola ET1 Integrator Manual

4 - 16 ET1 Enterprise Tablet Integrator Guide
not starting with 414, 419, 434 or 439. Tries to scan the supplemental if it is present. If the
supplemental scanning failed, then the main bar code is returned.
•
Supplemental 977 - Enables (auto-discriminate) supplemental for UPC/EAN codes starting with 977.
Disables reading of supplementals for another UPC/EAN barcode not starting with 977. Tries to scan
the supplemental if it is present. If the supplemental scanning failed, then the main bar code is
returned.
•
Retry Count - Retry count for auto-discriminating for supplementals. Possible values are 2 to 20
inclusive. Note that this flag is only considered if Supplemental Mode - UPC EAN is set to one of the
following values: Supplementals Auto, Supplementals Smart, Supplementals 378-379,
Supplementals 978-979, Supplementals 977 or Supplementals 414-419-434-439 (2 to 20, default 10).
•
Bookland - Enable or disable this option. A check in the checkbox indicates that the option is enabled.
•
Coupon - Enables Coupon code decoding. Note that in order to successfully decode Coupon codes, all
of the correct decoders must be enabled. A check in the checkbox indicates that the option is enabled.
•
Convert DataBar To UPC EAN - If this is set it converts DataBar bar codes to UPC/EAN format. For this
setting to work UPC/EAN symbologies must be enabled. A check in the checkbox indicates that the
option is enabled.

Reader Params

Allows the configuration of parameters specific to the selected bar code reader.
•
Beam Timer - Sets the maximum amount of time that the reader remains on (0 - 60,000 ms in
increments of 100 ms). A value of 0 sets the reader to stay on indefinitely (default -15000).
•
Linear Security Level - Sets the number of times a bar code is read to confirm an accurate decode.
•
Security Redundancy and Length - Two times read redundancy based on redundancy flags and
code length.
•
Security Short or Codabar - Two times read redundancy if short bar code or Codabar.
•
Security All Twice - Two times read redundancy for all bar codes (default).
•
Security Long and Short - Two times read redundancy for long bar codes, three times for short bar
codes.
•
Security All Thrice - Three times read redundancy for all bar codes.
•
Picklist - Allows the imager to decode only the bar code that is directly under the cross-hair/reticle (+)
part of the pattern. This feature is useful in applications where multiple bar codes may appear in the field
of view during a decode session and only one of them is targeted for decode.
•
Disable – Disables Picklist mode. Any bar code within the field of view can be decoded (default).
•
Centered - Enables the Picklist mode so that only the bar code in the center of the image is decoded.
This is most useful when used in conjunction with the static and dynamic reticle viewfinder modes.
Note: This mode is only valid for decoder modules that supports a viewfinder. If one tries to set this for
a unsupported decoder then the device would issue an error. (Camera scanner only).
•
Reticle - Enables the Picklist mode so that only the bar code that is directly under the cross-hair
(reticle) is decoded. This is useful when used in conjunction with the static and dynamic reticle
viewfinder modes. (Scan Module Only)