Installation Using Usb Connection; Using Android Debug Bridge - Motorola ET1 Integrator Manual

•
Android Debug Bridge, see
•
Mobility Services Platform (MSP) for Android.

Installation Using USB Connection

To install an application using a USB connection:
Connect the USB/Charge cable to the ET1 and the host computer or place the ET1 in the Single-slot USB
1.
Docking cradle to the host computer. See
Open the Notification Panel.
2.
Touch USB Connected.
3.
Touch Turn on USB storage.
4.
The ET1 displays as a Removable Disk on the host computer.
5.
On the host computer, copy the application .apk file from the host computer to the Removable Disk.
6.
On the ET1, touch Turn off USB storage.
7.
Touch .
8.
Touch Launcher > File Browser to view files on microSD card.
9.
Locate the application .apk file.
10.
Touch the application file to begin the installation process.
11.
To confirm installation and accept what the application affects, touch Install. otherwise touch Cancel.
12.
Accept Installation Screen
Figure 9-1
Touch Open to open the application or Close to exit the installation process. The application appears in
13.
the Launcher.

Using Android Debug Bridge

Use ADB commands to install application onto the ET1.
CAUTION When connecting the ET1 to a host computer and mounting its microSD card, follow the host
computer's instructions for connecting and disconnecting USB devices, to avoid damaging or
corrupting files.
Using Android Debug Bridge on page 9-5
Chapter 2, Accessories
Application Deployment
for setup information.
9 - 5