ENTERPRISE TABLET QUICK START GUIDE...
Title of the software download you are requesting. If it is determined by Motorola Solutions that your device is entitled to the latest software release, you will receive an e-mail containing a link directing you to a Motorola Solutions Web site to download the appropriate software.
Features Microphone Light Sensor Communication LED Decode LED Battery Charge LED Front-facing Touch Screen Camera Programmable Buttons Back Button Home Button Menu Button...
Features USB Host Expansion Rear-facing Module, Scanning Module Secondary Microphone Camera Flash Camera or Scanning/MSR Module Power Button Right Scan/Action Left Scan/Action Button Button Battery Charging Battery Release Latch Battery Speaker Speaker Headset Jack I/O Connector HDMI Output Connector...
Getting Started Close the access door. To get started: Install SIM card (ET1N2 with GSM) • Install the battery • Charge the battery • Start the ET1 • Activate the ET1N2 on a mobile data network. • SIM Card...
For multi-user mode, refer to the ET1 Enterprise Tablet NOTE User Guide for login procedures. Press the Power button to turn on the ET1. As the ET1 starts the Tracks splash screen displays and then the Home screen appears. Slide up to unlock the screen.
CDMA Activation Touch Activate. The ET1N2 begins the activation process. If Prior to using the ET1N2 on a CDMA network, the ET1 must be the activation is unsuccessful, contact the service provider. registered with the service provider. Contact the service provider to set up an account and provide the MEID number (located under the battery).
. The APPS screen displays. information on configuring the ET1. Power Button Use the Power button to place the ET1 in suspend mode, battery swap mode, to reset the ET1 or to power off the ET1. All Apps icon Suspend Mode Press and release the Power button to place the ET1 in suspend mode.
Power button until the dialog box appears then touch Reset. Power Off Change Volume To power off the ET1, press and hold the Power button until the Press P1 to decrease the volume. Press P2 to increase the dialog box appears, then touch Power off. When the Power off volume.
On the screen, align the bar code in the viewing window. The ET1 reads and decodes the bar code data. The Decode LED turns green indicating a successful decode. Point the top of the ET1 at the bar code.
> and then touch the video icon Use the rear-facing camera to take photos and capture video. Point the ET1 at the subject. A microSD card is required to save photos and videos. NOTE On the screen, frame the subject in the window.
Bluetooth devices in the area and lists them under AVAILABLE DEVICES. Scroll through the list and select a device. The Bluetooth pairing request dialog box appears. Enter a PIN and touch OK, if required. Touch Refer to the ET1 Enterprise Tablet User Guide for NOTE supported Bluetooth profiles.
Slide the Wi-Fi switch to the ON position. Touch Wi-Fi. The Touch the Data enabled checkbox to turn on data connection. ET1 searches for WLANs in the area and lists them. A blue check appears in the checkbox. Select the desired network.
Press thumb against the side of the ET1 and battery. Using the index and middle fingers, move the battery release latch toward thumb and pull the battery out of the battery compartment. Align the tracks on the side of the replacement battery with the rails in the battery compartment.
Accessories The following accessories are available for the ET1: Single-slot Docking Cradle • Four-slot Charge Only Docking Cradle • Four-slot Battery Charger • Scanning Module • Scanning/MSR Module • Handstrap • Holster • Protective Rubber Bezel • USB/Charge Cable •...
Schaumburg, IL 60196-1078, U.S.A. http://www.motorolasolutions.com MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners. © 2013 Motorola Solutions, Inc. All Rights Reserved.