2 - 22 ET1 Enterprise Tablet Integrator Guide
Protective Rubber Bezel
To install the Protective Rubber Bezel:
Press the Power button until the Device options menu appears.
1.
Touch Power off.
2.
Remove the battery.
3.
Place the ET1 face down on a table.
4.
Remove two plugs covering the screws.
5.
Using a Torx T6 screwdriver, remove four Torx screws.
6.
Remove Screws
Figure 2-24
Using tool, pry bezel from top of ET1.
7.
Lift bezel from ET1.
8.