Page of 12
ET1
ENTERPRISE TABLET
QUICK START GUIDE

   Also See for Motorola ET1

   Summary of Contents for Motorola ET1

  • Page 1

    ENTERPRISE TABLET QUICK START GUIDE...

  • Page 2

    Title of the software download you are requesting. If it is determined by Motorola Solutions that your device is entitled to the latest software release, you will receive an e-mail containing a link directing you to a Motorola Solutions Web site to download the appropriate software.

  • Page 3

    Features Microphone Light Sensor Communication LED Decode LED Battery Charge LED Front-facing Touch Screen Camera Programmable Buttons Back Button Home Button Menu Button...

  • Page 4

    Features Rear-facing USB Host Camera Flash Power Button Secondary Microphone Camera Expansion Module Right Scan/Action Left Scan/Action Button Button Battery Charging Battery Release Latch Battery Speaker Speaker Headset Jack I/O Connector HDMI Output Connector...

  • Page 5: Getting Started, Charge The Battery, Install The Battery

    For multi-user mode, refer to the ET1 Enterprise Tablet NOTE User Guide for login procedures. Press the Power button to turn on the ET1. As the ET1 starts the Tracks splash screen displays and then the Home screen appears. Slide up to unlock the screen.

  • Page 6: Power Button, Suspend Mode

    Launch Applications Power Button Use the Power button to place the ET1 in suspend mode, battery To launch an application: swap mode, to reset the ET1 or to power off the ET1. Touch the Launcher icon. The Launcher screen displays.

  • Page 7: Power Off, Lock The Screen

    Change Volume Power Off To power off the ET1, press and hold the Power button until the Press P1 to decrease the volume. Press P2 to increase the Device options dialog box appears, then touch Power off. volume. Note that these buttons are programmable and can be When the Power off dialog box appears, touch OK.

  • Page 8: Photos And Videos

    The ET1 reads and decodes the bar code data. The Decode To take a photo: LED turns green indicating a successful decode. Touch Launcher > Camera. The ET1 offers additional data capture options. Refer to NOTE Point the ET1 at the subject.

  • Page 9

    Status Bar indicating that Wi-Fi is enabled. Under Bluetooth settings, touch Scan for devices. The ET1 Touch Wi-Fi settings. The ET1 searches for WLANs in the begins searching for discoverable Bluetooth devices in the area and lists them under Wi-Fi networks.

  • Page 10: Battery Replacement

    Wait until the Scan LED turns off. Turn the ET1 over. Press thumb against the side of the ET1 and battery. Using the index and middle fingers, move the battery release latch toward thumb and pull the battery out of the battery compartment.

  • Page 11

    Accessories The following accessories are available for the ET1: Single-slot Docking Cradle • Four-slot Charge Only Docking Cradle • Four-slot Battery Charger • Handstrap • USB/Charge Cable • • Two-way DC Cable Power supplies. •...

  • Page 12

    Schaumburg, IL 60196-1078, U.S.A. http://www.motorolasolutions.com MOTOROLA, MOTO, MOTOROLA SOLUTIONS and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC and are used under license. All other trademarks are the property of their respective owners. © 2011 Motorola Solutions, Inc. All Rights Reserved.

Comments to this Manuals

Symbols: 0
Latest comments: