Powering On The Et1; Powering Off The Et1; Wan Activation; Gsm Activation - Motorola ET1 Integrator Manual

Powering On the ET1

Press the Power button until the Battery Charge LED flashes three times. The splash screen displays for about
a minute as the ET1 initializes its flash file system. Note that these windows also appear upon reset.

Powering Off the ET1

Press and hold the Power button until the Device options menu appears. Touch Power off and then OK.

WAN Activation

In order to use the WAN radio for data communication, the ET1N2 must be activated on the service provider's
network. By default, the ET1N2 is configured for a GSM network. To activate on a CDMA network, manual
configuration is required.
See Chapter 6, WWAN Configuration

GSM Activation

When the ET1N2 turns on it automatically configures for the network. If the SIM card requires a PIN, the PIN
screen appears. Enter the PIN and touch OK.

CDMA Activation

Prior to using the ET1N2 on a CDMA network, the ET1 must be registered with the service provider. Contact
the service provider to set up an account and provide the MEID number (located under the battery).
By default, the ET1N2 is configured for a GSM network. To activate on a CDMA network:
Touch > Settings > Wireless & networks > Mobile networks > Technology preferences > Network
1.
mode.
In the Network mode menu, select Sprint or Verizon. The ET1 switches the modem firmware and the
2.
Activation Dialog box appears.
Touch Activate. The ET1N2 begins the activation process. If the activation is unsuccessful, contact the
3.
service provider.

Replacing the Battery

NOTE Do not remove microSD card while in Battery Swap mode.
Ensure that the Battery Swap mode procedures are followed, otherwise the backup battery will deplete
quickly and on the ET1N2, SIM card data corruption might occur.
To replace the battery:
Press the Power button until the Device options menu displays.
1.
for detailed WAN configuration information.
Getting Started 1 - 5