TechniSat DIGIT ISIO STC Quick Start Manual page 57

Fault
Receiver cannot be
operated, switched on or off
USB device not recognised
Device switches off
independently
after a certain period
of time
Possible cause
Defective data stream -->
receiver blocked
USB device formatted for
wrong file system
Auto Standby function is
switched on
57
Remedy
Hold down the On / standby
button on the receiver or the
remote control for approx. 5
seconds.
Pull out mains adapter for
approx. 5 seconds and then
re-connect the device
Perform Flash-Reset:
Warning!
This will cause all
settings to be lost.
> Remove mains adapter
from the receiver
> Simultaneously
press and hold
down the standby
and the up arrow
keys on the device
.
> With the Standby and
the up arrow keys
pressed down, re-insert
the mains adapter
> Keep both buttons
pressed down for
approx. 5 sec.
then release. "Factory
setting" appears in the
display.
Format USB device for
FAT32 file format
Check Auto Standby setting
and disable if necessary.
(see Point 8.2.7)