Volume Control - TechniSat DIGIT ISIO STC Quick Start Manual

for Dolby Digital broadcasts
for subtitles
for HbbTV
The current time is shown in the right-hand upper corner of the screen.
7.5 Receiving encrypted channels
Your receiver is equipped with an integrated CONAX and NAGRAVISION decryption system
(smartcard reader) and a Common Interface for accepting a CI / CI+ module. This enables
you to receive and view encrypted channels. To do this, you must first either insert a CONAX
or an HD+ smartcard into the integrated card reader, or insert a CI / CI+ module with a valid
smartcard into the slots provided.
> Insert the CONAX or HD+ smartcard into the card slot in the integrated card reader
(gold-coloured chip facing down, and in the direction of insertion).
or
> Insert a CI / CI+ module into the slot.
> Insert the smartcard into the CI / CI+ module card slot. Ensure that the gold-coloured
chip on the smartcard is facing upwards, in the direction in which the card is inserted.
If you now select an encrypted channel, the digital receiver will automatically check the card
reader and the CI / CI+ slot and will display the channel in decoded form, assuming a valid
smartcard and an appropriate CI / CI+ module with a valid smartcard has been inserted.

7.6 Volume control

You have the option of adjusting the volume via your digital receiver. This facilitates
operation of the receiver, as it means you can access all the major functions on a single
remote control, and will only rarely have to resort to using the remote control for the TV.
To adjust the volume of your TV, press Volume + to increase the volume, and
>
Volume - to decrease it.
During volume adjustment, the currently set volume is displayed at the top of the
screen.
When you switch on the digital receiver, sound will be reproduced at the volume level
last set. When operating a Bluetooth audio device, please also note Point 8.4.7 in your
operating manual (headphone settings).
The volume control and mute button also control and mute the digital audio outputs
(not in the case of the Bitstream setting).
7.6.1 Switching to mute
To switch the sound off (mute), press the Sound on / off button - press this button
>
again to switch the sound back on.
36