Initial Installation - TechniSat DIGIT ISIO STC Quick Start Manual

Some options are selected directly in this window. Other options for a number of
subordinate selection options are located in the options groups. Highlighting one of
these options groups automatically opens another window on the left.
You can use the up / down arrow keys within the options group to highlight one of
>
the options listed there.
By pressing the up / down arrow keys it is possible to move the highlight from line
to line, and to move upwards and downwards page by page using the page up /
down buttons.
The highlighted option is selected by pressing the OK button and you exit the options
>
selection area.
> If you do not want to select an option or wish to leave the options selection area
without making any changes, simply press the Option button until it is hidden.

6 Initial installation

After you have read the safety instructions and connected the device as described in
Chapter 5, you can then switch it on.
On initial installation of the TV, the AutoInstall installation wizard starts automatically. The
installation wizard allows you to make the most important settings for your digital receiver in
the simplest way possible.
Each step of the installation explains which settings can be made.
> In the installation wizard start window, you can cancel the initial installation by pressing
the red function button. The receiver then begins to run default pre-programming.
In the ensuing installation steps, you can press the OK key to accept the preselected
settings and move on to the next step of the installation.
By pressing the Back key, you can go back to the previous installation step, so you
can correct any wrong entries at any time.
The initial installation shown here simply serves as an example.
The exact process for the initial installation will depend on the settings you select. Therefore,
please follow all instructions displayed on screen carefully.
21